Peugeot 309 Gti parts wanted

[pug309gti]

Hi I'm after;
Aftermarket camshaft
Vernier pulley
Superchip ecu
Sunroom trim
Rear window lever trim
Wing mirror adjuster trim

Many thanks

[cheaproject]

OMP roll cage?

[pug309gti]

Have you got some more details please?

[scmick]

Skip Brown inlet manifold for twin weber 45 DCOE carbs...???
Mick

[pug309gti]

How much were you looking for, I'm guessing I'd need aftermarket management to run 45's?

[owelly]

Jenvey throttle bodies fit on a Weber fanimold but I'm guessing that would be getting expensive.

[pug309gti]

It's already past the cheap project stage! But yes that would be overkill I think

[scmick]

Am looking for £90 for the twin DCOE manifold. (will post a photo later).. It was bought new some years ago for the 1.9 GTi engine I intended to fit to my Talbot Samba oval racer (It had the front end of a 309 to take the bigger engines). The cars had to run on carbs. Unfortunately, health problems meant I had to give up racing and I sold the Samba rolling shell to a guy who intended to fit an Mi16 engine. The engine , still with its injection went to a local guy who'd blown his 309 engine and the 45 DCOE carbs were used on one of my SIMCA projects that I still have.
So I'm left with the inlet manifold which has never been on an engine..... I had intended to use the distributor from the original 1360 engine in the Samba for the ignition as it's driven off the end of the cam in the same way as the TU engine. I've since sold that distributor to a Samba owner in the SIMCA/Talbot club...
Mick